Call Us! 1-505-319-0919

Dishwasher Repair Service by Mr. Eds Appliance

About 75% of households in the United States have a dishwasher. While you can certainly get by without one, most people would say they won't buy a home without one after they get accustomed to the convenience. Do you have a dishwasher that won't start, won't clean dishes properly, or leaks water? Mr. Ed's Appliance offers the most competitive dishwasher rates for dishwasher repair in Albuquerque, NM area. Here are some of the most common dishwasher issues we see on a regular basis.

Dishwasher Won't Start

Dishwasher Repair Albuquerque NM Does your dishwasher stubbornly refuse to start? Sometimes this is a simple fix. For example, the door latch or door latch switch may be faulty and prevent the door from closing properly. The problem may also be caused by the timer, electronic control board, selector switch, motor start relay, thermal fuse, or drive motor. With some components, it may be most cost-effective to replace the dishwasher rather than repairing it.

Dishwasher is Leaking

There are a few places from which a dishwasher can develop a leak. One of the most common problems is a worn door gasket or seal around the detergent dispenser in the discharge housing gasket, both of which allow water to escape the tub. A leak can also originate in the drain hose or water supply hose connection. In some cases, these connections or hoses can be repaired, although replacement is sometimes required. Other components that may cause a leak on a dishwasher include the inlet valve, the pump, the float switch, and the spray arms.

Dishwasher Won't Clean Dishes

Is there anything more frustrating than opening your dishwasher after it runs a cycle to find dishes that still have food or soap residue? Sometimes this problem is caused by clogged spray arms, a clogged filter, or scale and residue buildup. Poor cleaning may even be caused by insufficient water, as a float stuck in the raised position will prevent the dishwasher from filling.

Dishwasher Won't Drain

Do you have standing water at the bottom of your dishwasher? There are several reasons why water may not drain completely from your dishwasher or even seep back into the appliance. The most common problem is a drainage basket and sump that has become blocked with food particles. The drain hose could also be kinked or damaged or the pump may be clogged with debris. In some cases, the problem is caused by a stuck float assembly or a blockage where the drain hose connects to a garbage disposal. While less common, a dishwasher may fail to drain water if the motor or timer have gone bad.

Contact Us Today

Can't imagine life without a functioning dishwasher? Tired of a dishwasher that leaks or can't get your dishes clean? Contact Mr. Ed’s Appliance Repair Albuquerque, NM today at 505-319-0919. We provides dishwasher repair in Albuquerque of all major brands including Kenmore, Maytag, GE, Kitchenaid, Bosche, and Whirlpool. We are proud to offer competitive rates with same-day service and free estimates throughout the Albuquerque and Rio Rancho are. Call us today for a free estimate.

If you are also having problems with your washer and dryer, then you could use our washer & dryer repair service in Albuquerque and visit our page that talks about all the services we repair.